Tap Repairs in Woody Point
Most tap repairs Woody Point households ring us about come down to a single worn part rather than a broken fixture. Woody Point sits on a headland where washer-era cottages and modern unit mixers share the same streets, so we see both designs every week. Every job is done by a licensed plumber, and you get a fixed quote before any work starts.
If we're late, $100 comes off your bill
- Licensed and InsuredEvery job done by a licensed plumber. QBCC No: 15024607
- Fixed Quote FirstFlat-rate pricing, agreed before any work starts
- Lifetime Labour WarrantyBacked by our Fix-It-or-It's-Free guarantee (T&Cs apply)
- $0 Call-Out FeesNo extra charge for nights, weekends or public holidays

Which Part Fails in Your Tap
Two tap designs do most of the work on this peninsula, and each seals differently: a washer tap closes on a rubber washer, a mixer on a ceramic disc cartridge.
A washer tap is the older design, with a hot handle and a cold handle that each wind around several times. A spindle threads down inside the body and bears on a metal valve seat to shut the water off.
The jumper valve is the small part at the foot of that spindle, and it carries the washer down onto the seat. On a mixer tap, one lever controls hot and cold, the handle swings about a quarter turn, and two ceramic discs inside the cartridge do the sealing.

Tap Leaks at the Spout, Handle and Base
A drip at the spout, even with the tap shut off hard, tells you the sealing part has given up, and where else the water turns up narrows it further:
Spout
water escaping the spout means the washer, or the seat under it, on an older tap, or the whole cartridge on a mixer.
Handle
dampness creeping out around the handle while the tap is on usually means a perished O-ring under the spindle.
Base
wetness at the foot of the tap, or staining under the sink, points to O-rings, a joint that has come undone, or a cracked tap body.
Shut the water down before anything comes apart: use the isolation valve beside the tap where one exists, or the stop tap at the meter otherwise. Turn the meter's stop tap clockwise, and check first that no appliance, the hot water system included, depends on that supply.

What Affects the Cost of a Tap Repair
The price turns on the tap type, the part it takes, seat or body damage, and how close by the water shuts off. You see the figure in writing once our plumber has seen the job.
The usual drivers:
Tap type
a standard washer tap and a sealed mixer cartridge are different jobs with different parts.
Seat or body damage
a scored valve seat or a cracked body pushes the job past a simple parts swap.
A leak that outlives fresh parts
new washers or cartridges that still leak point to something deeper in the body.
Isolation
an isolation valve at the fixture makes the job faster than shutting the whole property down.
How many taps
doing every basin in the house on one visit changes the scope.
A sound body with one worn part is always worth repairing, and a tap that drips for months can send thousands of litres down the drain. Unitywater's concealed leak adjustment leaves leaking taps out, so that wasted water stays on your bill with no offset. A body that is done, though, is where our tap replacement service takes over.

Tap Washers, Cartridges and the Licence Line
Queensland splits this work two ways, and knowing where the line sits saves an argument later. The QBCC lists a tap's jumper valve or washer as unregulated work, open to anyone with the right know-how, provided the finished result still meets the standards.
Everything else around a tap needs a licensed plumber:
Cartridges, O-rings and spindles
repairing a tap fitting counts as minor work, done by a QBCC licensee with no council permit and no Form 4 lodgement.
Swapping the whole tap
fitting a new tap is licensed work too, since it sits outside the short householder list.
Rentals
a dripping tap is not on the tenancy Act's emergency list, so it counts as routine. The tenant lets the property manager know, and the manager or owner arranges the fix within a reasonable time.
A tenant whose manager drags the chain can issue a Form 11, the notice that demands a breach be remedied, and that hands the owner or manager at least a week to act. Either way, the repairs themselves still land with a licensed plumber, which is where we come in.

Old Washers and New Mixers on the Headland
Both tap generations turn up on the same run, sometimes in the one street, so the tap repairs Woody Point books with us cover each era on its own terms. At the last census, 54.4% of dwellings here were detached houses and 33.9% were flats or apartments. That mix puts mid-century washer taps in a cottage off Victoria Avenue beside newer unit-block mixers near Hawthorne Street.
New stock keeps arriving too. Area-level building approvals added 321 dwellings over five years, 76 of them in 2021-22 alone, so fresh mixers reach us straight out of new kitchens and bathrooms. Bay air works on older outdoor fittings between visits, which is worth a check whenever we are on site for anything else.
Our tap and toilet plumbing work covers the full fixture list, and a cistern that runs all night often books the same visit as a dripping spout, so toilet repairs ride along whenever it suits.
How Your Tap Repair Visit Runs
- 1

Call or message us
Ring (07) 3523 7172 or use the form and describe what's going on in Woody Point. A few details up front mean the right gear comes on the first trip.
- 2

We diagnose the tap on site
We shut off the water, strip the tap down and find the worn part, whether that is a washer, a jumper valve, an O-ring or a whole cartridge. You see what we found before anything goes back together.
- 3

Fixed quote, then the work
We give you a fixed quote before any work starts. It's flat-rate pricing with no hidden fees, and we only start once you approve it.
- 4

Settle up your way
Card and EFTPOS payment on site when the job's finished, or Fix now, pay later if that suits you better.
Plumbing job in Woody Point?
$0 call-out fees, available 24/7, and same-day where we can.
Tap Repair Questions From Around the Headland
Call (07) 3523 7172Why does my mixer tap feel stiff to turn?
Stiffness usually points to a worn or gritty cartridge or spindle. The cartridge gets replaced whole, matched to that tap's make and model, since one cartridge does not fit every brand. If the tap still seals, the drip can wait for a booked visit.
Is replacing a ceramic cartridge licensed work in Woody Point?
Yes, a ceramic cartridge is not named on the QBCC's unregulated list, so swapping one counts as minor work done by a licensed plumber in Woody Point. No permit applies and no Form 4 goes in, so the job is quick to book and quick to do.
Does a tap repair need a permit or a Form 4?
No, minor work needs neither a council permit nor a Form 4 lodgement anywhere in Queensland. A washer swap is unregulated work and needs no approval or paperwork either, provided the finished job still meets the standards.
Is it worth repairing an old tap?
Yes, while the body stays sound and only the washer, O-ring or cartridge has worn, so an old tap in a Woody Point cottage is usually worth one repair visit. A cracked or heavily corroded body, or a leak that outlasts fresh parts, means a replacement tap is the better spend.
Will turning the tap off harder stop the drip?
No, forcing a tap shut grinds the washer into the valve seat and speeds up the wear underneath. The worn part needs replacing, and a harder shut only hides the drip for a week or two.
Book a Tap Repair in Woody PointWe'll call you back.
Book on (07) 3523 7172 for plumbing anywhere in Woody Point. We're available 24/7, there's no extra charge for nights, weekends or public holidays, and every job comes with $0 call-out fees.
To claim your $0 call-out fee, call (07) 3523 7172 today.